5.8. Memory – recall of the measurements (Unit should be turned on first)
This blood pressure monitor automatically stores each of the last 30 measurement val-
ues separately for 2 users. By pressing the MEMORY button, the last measurement as
well as previous 29 measurements (MR29, MR28, …MR1) can be displayed one after
the other. Data obtained in Average Mode is indicated by an “A“ symbol. If the memo-
ry is full, the next measurement will be added to memory and the oldest reading (MR 1) will be deleted.
5.9. Clearing the Memory – cancellation of all measurements
Attention! Before you delete all readings stored in the memory, make sure
you won’t need to refer to the readings at a later date. Keeping a written
record is prudent and may provide additional information for your next
physician visit. A log is included to record a history of your measurements.
In order to delete all stored readings, press the MEMORY button for at
least 7 seconds. The display will show the symbol “CL” and 3 short beeps
will sound to indicate deletion of stored readings. (Unit must be turned on.)
11
To Next Page
Loading...
Need help?
General
