5. Press the User/Time button again. The
last two characters (day) are now blinking.
6. The current day can now be entered by
pressing the MEMORY button. (Example: 14
x presses advances the day from the 1st to
15th)
7. Press the User/Time button again. The
display now switches to the current time,
during which the first character (Hour)
blinks.
8. The corresponding hour can now be
entered by pressing the MEMORY button.
(Example: 9 x presses)
1. Press the User/Time button for at least 3
seconds. The display now indicates the set
year, The last two characters are blinking.
2. The correct year can be entered by
pressing the MEMORY button. Once for
each change. (Example: 1 x press)
3. Press the User/Time button again. The
display now switches to the current date,
during which the first character (month)
blinks. Note: Holding the button down
speeds up the procedure.
4. The current month can now be entered
by pressing the MEMORY button. Example:
pressing 5 x advances 5 months)
6
4.4. Setting the time and date
This blood pressure monitor incorporates an integrated clock with date display. Time and date
are recorded along with pressure and pulse. After new batteries have been inserted, the clock
begins to run from the following setting: 2000-01-01 12:00 O’clock. You must then re-enter the date
and current time. Please proceed as follows (Example: Entering 2002-06-15 Time 09:30 AM):
To Next Page
Loading...
Need help?
General
