Review Measurement in Memory
Measurement memory function
This device automatically stores the last 120 measurement values of each user in memory for review.
Memories are not stored in guest mode.
Select the intended user (user 1 or user 2 or guest) by pressing the User indicator button.
Viewing the average of AM PM
Doctors recommend that you compare blood pressure measurements taken at the same time each
day to help ensure consistent conditions during measurements. To assist you, this blood pressure
monitor is equipped with AM/PM averaging capabilities.
•
Press “M” (Memory) button. The average reading for the current user will appear.
•
Press “M” (Memory) button again. The average of all AM readings (4 AM-12 PM), will be displayed
on the screen. “AM” will be displayed on the top of the screen.
•
Press “M” again. The average of all PM readings (6 PM-12 AM), will be displayed on the screen. “PM”
will be displayed on the top of the screen.
Viewing the stored values in memory
Pressing the M-button again, allows you to see the last performed measurement. The display first
shows «M» and a value, e.g.«M17». This means that there are 17 single values in the memory.
Pressing the M-button repeatedly enables you to move from one stored value to another. To scroll
through all individual readings, press “M” repeatedly.
Memory full
Pay attention that the maximum memory capacity of 120 memories is not exceeded. When the 120
memory is full, the oldest value is automatically overwritten with the 121st value.
Values should be evaluated by a doctor before the memory capacity is reached – otherwise data
will be lost.
Clearing all values in memory
If you are sure that you want to permanently remove all stored values, hold down the M-button when
device is in stand-by until «CL ALL» appears and then release the button. To permanently clear the
memory, press the SET button while «CL ALL» is flashing. Individual values cannot be cleared. Cancel
deletion: press ON/OFF button while «CL ALL» is flashing.
To Next Page
Loading...
