Microlife BPHJN3-D - Electromagnetic Compatibility Information; FCC Requirement

performance of the device.
Electromagnetic Compatibility Information
 This device is compliant with IEC 60601-1-2 Electromagnetic Disturbances standard.
 This device is not certified to be used in vicinity of medical equipment including high frequency
(HF) surgical equipment, magnetic resonance imaging (MRI) and computerized tomography (CT)
instruments.
 DO NOT use this device close to strong electromagnetic fields and portable radio frequency
communication devices (for example microwave oven and mobile devices). Keep a minimum
distance of 0.3 m from such devices when using this device.
 This device features Bluetooth(R) that emits radio frequency (RF) in the 2.4GHz band. Do not
use this device in locations where RF is restricted (for example, on a aircraft). Turn off the device
and remove the power source if necessary when in RF restricted locations.
 This device operates in an unlicensed ISM bad at 2.4GHz. In case this device is used near other
wireless devices (for example wireless LAN) which operates on the same frequency band as this
device, there is a possibility that interference may occur. If interference occurs, stop the
operation of other devices or relocate this product away from other wireless devices before
using it.
FCC Requirement
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
–
Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.