INSTALLATION CONFIGURATION
Standard installation requires the use of 1/8 in. copper or stainless steel gas supply lines, located
in the instrument accessories kit.
A nonstandard installation will be created if another gas supply line is used or if the gas cylinders
cannot be placed within 6 ft (2 m) of the analyzer. There may be additional costs associated with a
nonstandard installation. Please contact the Micromeritics Service Department at 1-770-662-3666
to discuss a nonstandard installation.
COMPUTER SYSTEM
We recommend purchasing the computer system from Micromeritics. Micromeritics thoroughly
tests operating systems with the Micromeritics applications and offer technical support and
maintenance for the computers we provide. For analyzers not installed by Micromeritics, please
note:
n The labor and expense costs associated with delays traceable to a computer sys-
tem not purchased from Micromeritics are not part of a standard installation.
n Micromeritics is not responsible for providing assistance for the connection to a
company network or LIMS.
n During installation, Administrator rights will be required to make changes to the Eth-
ernet settings. If access cannot be granted to the Service Technician, an
ITrepresentative must be readily available to make these changes or additional
charges may apply.
Installation Configuration
Flex Series Pre-installation Instructions and Checklist
350-42870-01 (Rev H) — Apr 2021
2 - 3
To Next Page
Loading...
Need help?
General
