Setup and Self Test
UG0048 User Guide Revision 5.1 14
4 Setup and Self Test
This section provides information about how to set up and test the ProASIC3/E Starter Kit board.
4.1 Software Installation
The ProASIC3/E Starter Kit includes Libero SoC software. For the latest version of Libero SoC software,
go to https://www.microsemi.com/products/fpga-soc/design-resources/design-software/libero-
soc#overview.
For Libero SoC software installation instructions, see the Libero SoC Quick Start Guide.
4.2 Hardware Installation
FlashPro4 is required to use the ProASIC3/E Starter Kit. For software and hardware installation
instructions, see the FlashPro User Guide.
4.3 Testing the Starter Kit Board
See Testing the Board, page 19.
4.4 Programming the Test File
To retest the Starter Kit board at any time, use the test program to reprogram the board. Download the
ProASIC3/E Starter Kit example design at: https://www.microsemi.com/products/fpga-soc/design-
resources/dev-kits/proasic3/proasic3-starter-kit#documents.
Using FlashPro software, program the example design on ProASIC3/E device. This design is currently
implemented for the A3PE1500 die size. For a device of a different size, it is possible to recompile the
design into other device sizes. For information about retargeting the device, see the Designer User’s
Guide.
For instructions on programming the device using FlashPro4, see the FlashPro User Guide.
To Next Page
Loading...