49 M1179886
10. Fit C-cover – Follow steps 2-4 of the C-cover reassembly instructions. Do not install any Feet screws.
11. Check AB-cover alignment – Close the device and conrm ushness of feeler gauge to display module
cover across the rear corners of each hinge.
a. If ush, move to next step in this section.
b. If not ush, follow steps for removing AB-hinge screws and steps for 9a thru 9c again until ush. Then
follow steps for C-cover reassembly.
12. rSSD Install – Follow steps for Procedure – Installation (rSSD) section (page 37).
13. C-cover Install – Follow steps for Procedure – Installation (C-cover Keyboard metal type) section (page 27).
14. Run SDT – Power on device. Validate full device functionality by running SDT tool.
a. If an SDT failure occurs, assess failure to determine if caused by any improper or missed step in the repair
process and correct.
b. Any failure that is not correctable should result in device exchange.
15. Install Feet – If SDT tests pass and no further actions are to be performed on the device, follow steps for
Procedure – Installation (Non-Skid Feet) section (page 20).
To Next Page
Loading...
Need help?
General
