6 Setting up Xpress
Disc Production Workspace
The workspace for the Xpress disc production system should be in an
environment free of dust and debris. Contamination can adversely affect
production yield, degrade the quality of the discs produced, and reduce
the life of the equipment. A typical office environment will provide the
necessary cleanliness, temperature, and humidity control required to
maximize system performance and service life.
The workspace should have the following features:
Sturdy workspace
A working surface sturdy enough to support a total weight of
200 lbs.
Large workspace
A large enough workspace: a recommended minimum of
60” W x 48” D x 36” H, with 36” of clearance above.
Electrical power
The production system needs adequate power and enough power
receptacles. Ensure that the power receptacles are properly grounded.
The average power requirement for the entire system is 250 watts. The
peak requirement may reach 400 watts. Microtech recommends using a
surge protector and/or power conditioner for optimal setup.
Adequate lighting
There should be enough light both for operating the equipment and for
examining the discs you produce and print. In addition, if the
ImageAligner option is installed, adequate lighting for the digital camera
to capture disc images is necessary (adequate light must be available
even when the system is running jobs unattended after-hours). Direct
sunlight or spotlights can adversely affect the robotic sensors of the
Xpress as well as affecting the performance of the ImageAligner.
Document storage
Keep the documentation and software handy for future assistance,
trouble shooting, etc.
Important Unpacking
Information
Be sure to save all packing
material in case you need
to move or ship your
system.
Microtech Systems will
only accept merchandise
returned in the original
shipping container.
To Next Page
Loading...