Microtek ScanMaker 3700 Supplementary Guide

Launching and exiting MSC utility
Launching and Exiting the MSC
utility
Launch your Microtek Scanner Configuration (MSC) utility by:
● Double-clicking the Microtek Scanner Configuration (MSC) icon
from the desktop.
● Pressing the Cancel/Setup button on your scanner (if your scanner is
not working).
To exit the Microtek Scanner Configuration (MSC) utility:
● Click the Exit button located at the top-right corner (OK button on
the bottom-right corner for the Mac) of the Microtek Scanner
Configuration (MSC) panel.
Using the Microtek Scanner Configuration (MSC) utility
file:///D|/msc/WebHelp/Launching_exiting_MSC.htm [8/20/03 2:27:15 AM]

Microtek ScanMaker 3700 Specifications

General

Brand	Microtek
Model	ScanMaker 3700
Category	Scanner
Language	English