14 ScanMaker i700 Installing and Getting Started
C. Using the EZ-Lock 6 x 17 cm (120) Panoramic Film
Holder
The EZ-Lock 6 x 17 cm (120) Panoramic Film Holder can hold 1 piece of 120
panoramic film or a variety of various-sized film, such as 4 pieces of 6 x 4.5 cm film,
or 2 pieces each of 6 x 6 cm film, 6 x 7 cm film, and 6 x 9 cm film.
1. Load the film face down inside the holder.
a) Push on the side to open the lid.
b) Place the film face down into the holder.
c) Pull down the side to close the lid.
2. Raise the scanner lid, then place the holder with the loaded film on the scanner
glass surface as shown in the illustration.
To make sure the auto
multiframe cropping
feature performs
correctly, align the
holder’s front edges
flush against the top
ruler of the scanner.
3. Follow the procedures (steps 3 through 10) for scanning 35mm filmstrips to carry
out scanning.
The calibration window on the glass
surface should be kept clear and free
from any obstruction during scanning.
To Next Page
Loading...
Need help?
General