ScanMaker i700 Installing and Getting Started 15
D. Using the EZ-Lock 4" x 5" / 6 x 9 cm (120) Film
Holder
The EZ-Lock 4" x 5" / 6 x 9 cm (120) Film Holder can hold 1 piece of 4" x 5" film.
It can also hold different sizes of 120 film, such as 2 pieces of 6 x 4.5 cm film, or 1
piece each of 6 x 6 cm film, 6 x 7 cm film, and 6 x 9 cm film.
1. Load the film face down inside the
holder. Slide the film along the slots of
the holder until the film is fully loaded.
To make sure the auto
multiframe cropping
feature performs
correctly, align the
holder’s front edges
flush against the top
ruler of the scanner.
2. Raise the scanner lid, then place the holder with the loaded film on the scanner
glass surface as shown in the illustration.
3. Follow the procedures (steps 3 through 10) for scanning 35mm filmstrips to carry
out scanning.
The calibration window on the glass
surface should be kept clear and free
from any obstruction during scanning.
To Next Page
Loading...
Need help?
General