ScanMaker i700 Supplement 23
D. Scanning 4" x 5" / 6 x 9 cm (120) Film
To scan 4" x 5" or 6 x 9 cm (120) film, use the EZ-Lock 4" x 5" / 6 x 9 cm (120) Film
Holder which can hold 1 piece of 4" x 5" film, 2 pieces of 6 x 4.5 cm, or 1 piece each at
a time of 6 x 6 cm film, 6 x 7 cm film, and 6 x 9 cm film.
1. Load the film face down inside the
holder. Slide the film along the slots of
the holder until the film is fully loaded.
To make sure the auto
multiframe cropping
feature performs
correctly, align the
holder’s front edges
flush against the top
ruler of the scanner.
2. Raise the scanner lid, then place the holder with the loaded film on the scan bed.
3. Follow the procedures (steps 3 through 10) for scanning 35mm filmstrips to carry
out scanning.
The calibration window on the
glass surface should be kept clear
and free from any obstruction
during scanning.
To Next Page
Loading...
