TROUBLE SHOOTING
Cure Your Appliance When Needed
If a fault occurs, before calling the after-sales service, please ensure that is not because
of incorrect operations and refer to the fault table, attempt to correct the fault yourself.
You can often easily rectify technical faults on the appliance yourself.
If a dish does not turn out exactly as you wanted, you can find many tips and instruc
tions for preparation at the end of the operating manual.
Fault Possible Cause Notes/remedy
• The appliance
does not work.
• Faulty fuse.
• Check the circuit breaker in the fuse
box.
• Power cut
• Check whether the kitchen light or
other kitchen appliances are working.
• Knobs have
fallen out of
the support
in the control
panel.
• Knobs have been
acci- dentally
disengaged.
• Knobs can be removed.
Simply place knobs back in their
support in the control panel and push
them in so that they engage and can
be turned as usual.
• Knobs can
no longer be
turned easily.
• There is dirt
under knobs
• Knobs can be removed.
To disengage knobs, simply remove
them from the support.
Alternatively, press on the outer edge
of knobs so that they tip and can be
picked up easily.
Carefully clean the knobs using a cloth
and soapy water. Dry with a soft cloth.
Do not use any sharp or abrasive
materials.
Do not soak or clean in the dishwasher.
Do not remove knobs too often so that
the support remains stable.
• Fan does not work all the time in the
mode: “Fan Heating”
• This is a normal operation due to the
best possible heat distribution and
best possible performance of the oven.
• After a cooking process a noise can be
heard and a air flow in the near of the
control panel can be observed.
• The cooling fan is still working, to
prevent high moisture conditions in
the cavity and cool down the oven for
your convenience. The cooling fan will
switch off automatically.
To Next Page
Loading...
