Service Manual_2020-V1.0
29
7.2 Parts inside the refrigerator
1）
1) Hold the front edge of glass shelf by uplift by certain
angle.
2）Uplift the glass shelf ,and separate it from the shelf.
1) Pull out the fruit and vegetable box to the maximum
position;
2) Grasp the handle, lift it up, and take out the fruit and
vegetable box.
Refrigerator sliding shelf
1) Take out the glass shelf on the sliding shelf.
2) Pull the sliding shelf to the maximum location;
3) Take out the sliding shelf upward.
1) Press the claw on left and right side of glass shelf
bottom upward;
2) Remove it from the notch of the glass shelf, and take
out the glass shelf.
Variable temperature chamber drawer
1) Open the variable temperature door to the place of
maximum stroke, hold both sides of the drawer, lift the
tail, pull it backwards till the slide rail supporting claw is
separated from the drawer;
2) Lift the front end of the drawer for a certain angle and
move 20mm to the inside of the box, rotate over the rear,
and take out the drawer.
To Next Page
Loading...
Need help?
General
