R410A Full DC Inverter Split Duct Type Technical Manual MCAC-UTSM-201503
77
② Press " " to confirm parameter selection (details parameter codes' corresponding time
refer to table 2.3).
③ After setting successfully, the function selection icon and parameter selection icon will
be lighted on, the screen will display “Setting successfully” (as show in b part of the Fig.
A). After 3 seconds will exit optional function setting automatically, and the screen will be
back to normal display. After entering optional function setting, no operations in 5
seconds will exit function selection automatically, the setting parameter will not change.
Only press “ ” key to confirm the parameter then the setting parameter will save.
Table 2.1: The code of selecting the Table 2.2: The code of different times
clear filter function of reminding clear filter
※ Dial code operation specification
Table 2.3
ON
1
2
3
Dial code 1
Dial code 2
Dial code 3
Only display, no function
Cleaning filter screen
reminding
To Next Page
Loading...
