5. After self-cleaning, if there is any residual stain on the nozzle, please wipe it with a damp cloth, and
do not rinse with water.
6. After cleaning, hold the handle of the roller brush with your hand, align the other side of the roller
brush with the right cover, then put the handle end into the slot; if not used immediately, put the brush
in a ventilated place to dry before installation.
7. After cleaning, align the clips at both ends of the front cover of the roller brush with the slots at both
ends of the brush, rotate and press the handle of the flip cover of the brush until there is a click, which
indicates that the installation is successful.
Nozzle
Handle end
Driven wheel
To Next Page
Loading...
