Page 5
midlandusa.com
Model MXT500
INSTALLING YOUR RADIO
Preparation for Installation
This radio may be installed in any 12-volt negative ground system vehicle.
Most current U.S. and foreign vehicles use a negative ground system,
but some older models and some newer large trucks may have a positive
JURXQG&KHFNWKHVSHFL¿FDWLRQVIRU\RXUYHKLFOHEHIRUHEHJLQQLQJLQVWDO-
lation. Generally, you have a negative-ground system if the negative (-)
battery terminal is connected to the motor block. Contact your dealer if you
are unable to determine your vehicle’s polarity system.
• Read these instructions completely before beginning installation.
• Read and follow all safety precautions in your vehicle’s Service
Manual.
• Make sure all necessary tools, materials, and parts are on hand.
• Disconnect the negative (-) battery cable before installing your radio.
Be sure to reconnect the cable when installation is complete.
• Determine a mounting location for your radio. Choose a location that
does not impair visibility or interfere with driving. Also take into
consideration the routing and length of the lead wires and cables to the
power source, antenna, and/or optional external speaker.
CAUTION: Extreme care should be exercised when drilling into the dash to
avoid damage to under dash electronic ignition, cruise control, instrument
and/or accessory wiring.
CAUTION: Extreme care should be exercised when drilling into the dash
to avoid damage to under dash electronic ignition, cruise
control, instrument and/or accessory wiring.
Jl1
OLAN
o®
____________
_
UJNIDERDASI-II
MOUJNIT
To Next Page
Loading...
Need help?
General
