Midtronics Inc. 7000 Monroe Street Willowbrook, IL 60527
24
Appendix A: Recommended Scanning Procedure CPX-900
Appendix A: Recommended Scanning Procedure
The CPX-900 uses an optional 1D/2D barcode scanner built into the back of the tester to scan the
VIN of the vehicle being tested. This number is then cross referenced with the original equipment
manufacturer's battery specications stored in the tester's database and displayed on the tester
screen.
NOTE:
Barcode types supported by the CPX-900 include A: 1D: Code 39, Code 128, UPC,
Codabar, GS1-Limited; 2D: PDF417, QR Code: Model 2, and Data Matrix type barcodes.
Scanning Tips
• Barcode Scanner: Located in the upper left portion on the back of the tester.
VIN Barcode
Scanner
Drivers Door Frame
Windshield
• Hold Steady: Hold the tester steady when scanning the VIN barcode. This allows the user to
clearly see the barcode and allows the scanner to focus on it.
• Clean Barcode/Windshield: Surface dirt can interfere with the scanning process. If necessary
wipe the VIN barcode with a cloth or your nger remove any surface dirt.
• Lighting/Glare: If sunlight is shining directly onto the VIN barcode, try pivoting the scanner
up or down slightly to reduce any glare.
To Next Page
Loading...
Need help?
General
