Midtronics intellect EXP-1000

Questions and Answers:

N
nicholas49Aug 3, 2025
What to do if data will not print on Midtronics Test Equipment?
- J
  Janice MortonAug 3, 2025
  If data won't print from your Midtronics Test Equipment, first, press the END button to cancel the print job. Ensure that the IR transmitter and receiver are properly aligned, and then attempt to print the test results again. Also, direct sunlight can interfere with the data transmission, so move the printer and EXP from direct sunlight. If the printed characters are unclear or partially missing, try recharging the battery and reprinting. The printer may be off, as it shuts off after 2 minutes of inactivity. Briefly press the MODE button to turn it on; the green STATUS light should illuminate.
T
tylerpattersonAug 11, 2025
Why does the display not turn on for my Midtronics Test Equipment?
- S
  Steven LeeAug 11, 2025
  If the display on your Midtronics Test Equipment doesn't turn on, it could be due to a low vehicle battery (below 1 volt). In this case, fully charge the battery and retest. Alternatively, the analyzer's 6 AA batteries might need replacement. Replace the batteries, alkaline batteries are recommended.
S
Shannon YoungAug 23, 2025
What to do if the STATUS LED flashes on a Midtronics printer?
- S
  Steven HessAug 23, 2025
  If the STATUS LED is flashing on your Midtronics printer, it could be due to several reasons. Check if the printer is out of paper and insert new paper if needed. The thermal head may be too hot; allow it to cool down. Also, the batteries might be weak; recharge the printer batteries for 16 hours.

Midtronics intellect EXP-1000 Specifications

General

Battery Testing	Yes
Starting and Charging System Testing	Yes
Charging System Test	Yes
Starter Test	Yes
Alternator Test	Yes
Application	Automotive, Commercial
Display	Color Touchscreen
Test Capabilities	Battery, Starting, and Charging System testing
Data Storage	Internal memory for test results
Printer	Optional
Connectivity	USB
Power Source	Internal Battery, Vehicle Battery
Battery Test Technology	Conductance
Battery Types Supported	Flooded, AGM, Gel, EFB
Operating Temperature Range	32°F to 122°F (0°C to 50°C)