Miele CM 7750 - Removing and Cleaning the Cup Sensor

Cleaning and care
78
 Clean the surfaces of the central
spout with a damp cloth.
If the milk tube is blocked, clean it
under running water with the brush
supplied:
 Insert the brush in the pipework.
Move it back and forth until all milk
residue has been removed.
Reassembling the central spout
The dispensing unit is easier to
reassemble if the individual parts are
dampened with water beforehand.
 Reassemble the dispensing unit.
Push the spouts firmly back onto
the dispensing unit.
Make sure that all parts are tightly
connected to one another.
 Push the dispensing unit back into
the central spout and replace the
stainless steel cover.
 Touch OK.
Useful tip: If the coffee machine is
switched off, the central spout
components can be removed and
cleaned at any time.
Removing and cleaning the
cup sensor
The cup sensor is located underneath
the central spout.
Clean the cup sensor daily by hand with
warm water and a little washing-up
liquid.
 Push the two locking catches
together (see arrows).
The cup sensor will be released.
 Clean the cup sensor.
To refit:
 Push the cup sensor from underneath
into the holder on the central spout.