Problem solving guide
95
Problem Possible cause and remedy
F73 or
Check the brew unit
The brew unit cannot be positioned correctly.
Switch the machine off with the On/Off sensor.
Remove the brew unit and clean it by hand.
Push the coffee ejector of the brew unit into the
correct position (see diagram).
Do not fit the brew unit. Close the appliance door
and switch the machine on with the On/Off
sensor.
This will initialise the brew unit motor and put it back
into the start position.
When Insert the brew unit appears in the display,
open the appliance door and put the brew unit
back in the machine. Close the appliance door.
If the message appears again, reduce the amount of
coffee and/or select a finer grinder setting. Some
types of coffee have a much higher grinding volume.
To Next Page
Loading...
