To programme the machine,
^
Turn the selector to the programming position. The
machine is now in programming mode and will
respond according to the symbols shown under
the buttons.
^
By pressing the - or e button
–
the required programming option in the display
can be highlighted with an asterisk. Press ENTER
to select the option.
– the settings of the various programming options
can be altered.
– a time can be entered for the Standby option.
^ By pressing ENTER
– a programming option highlighted with an asterisk
can be selected.
–
an alteration to the programmed settings can be
saved.
If a setting is altered by mistake, do not
press ENTER. Turn the selector to
position "0". The altered setting will not
be saved and the original setting will be retained.
Programming the machine
14
To Next Page
Loading...
