^
Press the e button to switch the pre-grinding
function to On or Off.
^
Press ENTER to save this setting, or
turn the selector to "0" to undo the alterations if a
mistake has been made.
This will bring you back from the sub-menu.
Switching the programmed quantity of
hot water on or off
If the function "Prog. hot water" is switched on, the
machine will dispense a precise, pre-programmed
quantity of hot water when the hot water button d
is pressed. (See "Setting the portion sizes"). When
the function is switched off, the machine will
dispense hot water freely if the hot water button d
is pressed, and continue to do so until the button d
is pressed again.
^ Turn the selector anti-clockwise to the
programming position.
The machine is now in programming mode and
will respond according to the symbols shown
under the buttons.
The following will appear in the display:
^
Press the e button to highlight programming
option "Prog. Hot water" with an asterisk.
^
Press ENTER to confirm this option.
The sub-menu will appear in the display as
follows:
Programming the machine
23
To Next Page
Loading...
