Warning: Leave the cup under the
spouts for a few seconds after the coffee
has been dispensed to catch any
remaining drips.
^
The procedure is the same for the other two coffee
portion buttons.
The volumes of water programmed in will now be
dispensed every time.
Tea cup
To programme in the volume of water for
a tea cup, function "Prog. hot water" must
be switched on. (See "Switching the
programmed hot water on or off").
^ Turn the selector clockwise to the In Operation
position (with or without lighting).
^ If the machine is still cold the display will show the
following messages in succession:
"Fresh water?" to remind you to fill the water
container with cold, fresh drinking water.
If a rinsing programme is running "Rinsing" and
then "Rinsing/Pre-warming" will appear in the
display once the machine has started heating up.
Hot water will flow out of both coffee spouts into
the drip tray. The system is now rinsed out and
pre-warmed.
^
Wait until the following message appears in the
display:
Setting the portion sizes
32
To Next Page
Loading...
