All electrical work should be carried out only by a
suitably competent person, in strict accordance with
national and local safety regulations.
The machine is supplied with a mains cable with
moulded plug for connection to a 230 - 240 V mains
supply. The voltage, rated load and plug rating
are given on the data plate. Please ensure these
match the household mains supply.
Connection should be made via a switched socket
which is easily accessible after installation. For extra
safety it is advisable to install a residual current
device (RCD), with a trip current of 30 mA. Do not
connect via an extension lead.
Test marks Electrical safety, C-Tick Mark
Electrically suppressed according to AS/NZS 1044
Important
The wires in the mains lead are coloured in
accordance with the following code:
Green/yellow = earth
Blue = neutral
Brown = live
Where it is necessary to change plugs, if the colours
of the wires in the mains lead of this machine do not
correspond with the coloured markings identifying the
terminals of your plug, proceed as follows:
The wire which is coloured green and yellow must
be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol z or
coloured green, or green and yellow.
The wire which is coloured blue must be connected
to the terminal in the plug which is marked with the
letter N or coloured black.
The wire which is coloured brown must be
connected to the terminal in the plug which is
marked with the letter A or coloured red.
WARNING: THIS machine MUST BE EARTHED
Electrical connection AUS, NZ
71
To Next Page
Loading...
Need help?
General
