Miele CVA 620 User Manual

Rinsing
To remove any coffee grounds from the system the
water piping and brew unit must be rinsed through
every day before the first drink is prepared. If
programme "Rinsing" is set to "On" rinsing will start
automatically when the machine is cold and the
selector switch is set to the "On" position, with or
without lighting. This will warm the brew unit up at
the same time because hot water is used for the
rinse process. An appropriate message will appear
in the display.
If a drink has just been prepared the machine will
still run an automatic rinse programme shortly
before it goes into standby mode.
To prevent water from running into the
drip tray always place an empty cup
under the coffee spouts before making
the first cup of coffee.
^ Turn the selector anti-clockwise to the
programming position. The machine is now in
programming mode and will respond according to
the symbols shown under the buttons.
The following message will appear in the display:
^
Press the e button to highlight programming
option "Rinsing" with an asterisk.
^
Press ENTER to confirm this option.
The sub-menu will appear in the display as
follows:
Programming the machine
16

Miele CVA 620 Specifications

General

Pump pressure	15 bar
Controls	Touch controls
Programmable	Yes
Automatic Shut-off	Yes
Removable Brew Group	Yes
Adjustable Coffee Strength	Yes
Adjustable Coffee Temperature	Yes
Adjustable Milk Temperature	Yes
Adjustable Milk Froth	Yes
Cup Warmer	Yes
Rinse Program	Yes
Descaling Program	Yes
Cleaning Program	Yes
Languages	Multiple
Pre-brewing	Yes
Hot Water Function	Yes
Hot Milk Function	Yes
Milk Frothing Function	Yes
Cappuccino Function	Yes
Latte Macchiato Function	Yes
Espresso Function	Yes
Coffee Function	Yes
Voltage	230 V
Frequency	50 Hz