^
Place a container, minimum capacity 0.75 litres,
under both coffee spouts.
^
Press the rinsing and pre-warming button e.
(The machine must be operational and heated up,
otherwise it will not react when the buttons are
pressed.)
The following will appear in the display:
^
Press the e button to highlight programming
option "Rinsing cycle" with an asterisk.
^ Press ENTER.
The following will appear in the display:
A small amount of water will run out of the spouts,
then a small pause before requesting the next
amount of water. This procedure is carried out 4
times. On the last rinse about half a litre of water
runs out. The whole procedure takes approx. 5
minutes.
^
At the end of the rinsing cycle, the following will
appear in the display:
The brew unit has now been cleaned of
all residues and cleaning agents. Check
that the joints of the brew unit are still
sufficiently lubricated.
Cleaning and care
55
To Next Page
Loading...
