Drying unit (TA)
The CHANGE TA COARSE and
CHANGE TA FINE service
programmes have been allocated to
programme places 62 and 63
ex-works. If required, they can be
moved to other programme places.
See "System functions" in the
Programming manual.
Changing the coarse filter
The coarse filter should be changed
when the message CHANGE COARSE
FILTER flashes in the display.
^ Remove the service panel from the
control unit.
^
Remove the filter grille from the
drying unit.
^ Replace the coarse filter. The soft
side of the filter must face the front.
^ Replace the filter grille and push it
upwards to secure it.
^ Refit the service panel.
After the coarse filter has been
changed, reset the operating hours
counter to zero, as follows:
^ Select the Programme CHANGE TA
COARSE (see Operation: B - Free
programme selection).
^
Press the Start button 6.
When the service programme has
ended, a message will appear in the
display.
^
To üCONTINUE< press 6.
Maintenance
47
To Next Page
Loading...
