Adjusting the interior fittings
23
Moving the shelves
The shelves can be adjusted according
to the height of the food.
Raise the shelf, and pull it forwards
slightly until the notch at the side is in
line with the shelf support. It can then
be raised or lowered to the required
level.
The raised edge on the protective strip
at the back must face upwards to
prevent food from touching the back of
the appliance and freezing to it.
Stoppers prevent the shelves from
being dislodged by mistake.
Split shelf
In order to accommodate tall items in
the appliance, one of the shelves is
divided. The front section can be
pushed carefully under the rear section.
Push the rear half of the glass shelf
slightly upwards.
With the rear half pushed up, lift the
front half of the glass shelf up slightly
at the front, then slide it carefully
underneath the rear half.
Adjusting the door shelf /
bottle shelf
Push the door/bottle shelf upwards,
then remove it by pulling it forwards
Replace the door/bottle shelf at the
required position. Ensure that it is
securely pushed back into position.
To Next Page
Loading...
Need help?
General
