Miele PG 8056 - DOS Venting and Concentration Setting

Additional settings
82
DOS venting
 To avoid damage to the dispensing system, make sure before
venting that the detergent and rinse aid containers are adequately
filled and that the dispensing siphons are screwed securely to the
containers.
 Select DOS priming and confirm your selection with the OKbutton.
The dishwasher will then begin automatically venting the dispensing
system.
Dispensing system DOS priming will appear in the display.
Once this process is complete, Dispensing system successfully primed
will appear in the display.
 Press the OKbutton to acknowledge the message.
Setting the DOS
concentration level
Please observe dispensing recommendations made by the
manufacturer of the agent.
 Select Concentration and confirm your choice with theOKbutton.
Concentration levels are given as a percentage and can be set
between 0.01 and 2.00%.
The concentration level set then applies to all programs.
Display for DOS1:
Concentration
0,30 %
(0,01 - 2,00 %)
If a DOS G 60 module is connected to the dishwasher, the factory
set concentration level set must be reduced by half.
Display for DOS2 rinse aid and DOS4:
Concentration
0,04 %
(0,01 - 2,00 %)
 Use the arrow buttons  (higher)  (lower) to set the concentration
level you want and confirm your choice with the OK button.