Miele PG 8080 - Problem solving guide; Technical problems

Problem solving guide
49
With the aid of the following guide, most minor problems can be corrected without
contacting Miele. In many cases this will save you time and money because you
won't need to book a service technician.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions. Please note:
 Repairs must only be carried out by the Miele Professional Service, a Miele
authorised service agent or a suitably qualified technician in accordance with
local and national safety regulations. Unauthorised or incorrect repairs could be
dangerous and cause injury or damage to the appliance.
Technical problems
Problem Possible cause and remedy
When the dishwasher is
switched on with the
button, the display
stays dark and the
Start/Stop indicator
does not flash.
The dishwasher is not plugged in.
 Insert the plug and switch on at the socket.
The circuit breaker is defective or has tripped.
 Reset or replace the circuit breaker
(see data plate for minimum fuse rating).
The dishwasher stops
during a programme.
The circuit breaker is defective or has tripped.
 Reset or replace the circuit breaker (see data plate
for minimum fuse rating).
 If the circuit breaker trips again, contact Miele
Professional Service.
Interruption to the
power supply during
operation
If a temporary interruption to the power supply
occurs during a programme sequence, no action is
required.
The programme will continue after the interruption.
If the temperature in the wash cabinet drops below
the minimum value required for the programme block
during the interruption to the power supply, the
programme block will be repeated.
In the case of an interruption to the power supply of
≥20hours, the entire programme will be repeated.