Miele PG 8080 - The dishwasher does not fill;drain

Problem solving guide
51
The dishwasher does not fill/drain
Problem Possible cause and remedy
 Open stopcock
The tap is turned off.
 Turn on the tap fully.
 Inlet
Before rectifying the problem, you must:
 Switch the dishwasher off with the button.
Water intake is restricted.
 Turn on the tap fully and start the programme
again.
 Clean the water inlet filter (see "Maintenance").
 The water pressure at the intake is lower than
30kPa (0.3bar).
Seek professional advice.
 Drain
Before rectifying the problem, you must:
 Switch the dishwasher off with the button.
Drain fault.
There is water in the wash cabinet.
 Clean the filter combination (see "Cleaning and
care").
 Clean the drain pump (see "Maintenance").
 Clean the non-return valve (see "Maintenance").
 Remove any kink or loop in the drain hose.