Miele PG 8592 - Troubleshooting Wash Pressure and Load Issues

Problem solving guide
130
Problem Cause and remedy
Fault426, 526 Wash pressure is too low.
– Wash pressure is too low due to a heavy build-up of
foam. Spilled rinsing agent may not have been cleaned up
after being added.
 Follow the instructions regarding foam build-up in
“Chemical processes and technology”.
 Start the Rinsing programme in order to clean the wash
cabinet.
– The load carriers were loaded incorrectly or overloaded.
 Only use mobile units, baskets, modules and inserts
suitable for the particular application.
 Arrange hollow or deep-sided load items so that water
runs off them freely.
– The water lines are clogged or leaking.
 Check and clean the filters in the wash cabinet and spray
arms.
 Check the injector manifolds for possible leaks, e.g.:
– Are all caps and end caps in place?
– Are all connections fitted with nozzles, irrigation
sleeves, hose adapters or other irrigation connectors?
– Are installed silicone hoses undamaged?
 Check the washer’s water connectors in the back panel
of the wash cabinet to ensure that they are attached
tightly, and remove any blockages.
– The amount of water is insufficient for the application.
 Increase the amount of water (see “Programme
settings”). If necessary, consult the Customer Service
Department.
Fault432 The door was opened using the emergency release.
 See “Opening the door using the emergency release”.
Fault433 Protruding load items or other objects, e.g. towels, are
preventing the door from being closed properly by the
Comfort lock.
 Remove all objects and sort the load items so that they
do not obstruct the door.
 Close the door.