Miele PG 8592 - Process-Related Faults and Messages

Problem solving guide
133
Problem Cause and remedy
Fault 550 The waterproof system has been activated. One of the
water supply hoses might have a leak.
 Close the stopcocks.
 Contact the Miele Customer Service Department.
Fault555 Too much water has accumulated in the steam condenser.
Wash water may have been diverted behind the protective
panel of the steam condenser on the back wall of the wash
cabinet because of angled load items or injector nozzles.
 When installing angled injector nozzles and sorting load
items, ensure that the wash water outlets point towards
the centre of the wash cabinet.
 Restart the cleaning machine. Excess water is pumped
out automatically.
Fault559 There is a problem with the process documentation
interface. The machine has detected a module for an
Ethernet interface, but only a serial interface (RS232) is
activated in the controls.
Deactivate the RS232 interface:
 Open the menu for configuring the interface Further
settings/Interface and then select Ethernet.
 Wait approx. 90seconds. The Ethernet module XKM
3000 L Med needs this time for initialisation. It may be
necessary to reconfigure the interface.
Or
 Replace the Ethernet module XKM 3000 L Med with a
XKM RS232 10 Med module to set up a serial interface.
Fault578 The peak load cut-out has lasted longer than 3hours.
 Have your electrical system and your energy
management system tested by a suitably qualified
person.
Process-related faults and messages
Problem Cause and remedy
Fit a new HEPA filter! The maximum permissible operating hours for the HEPA
filter have been reached.
 Replace the HEPA filter with a new one.
 Reset the operating hours counter for the HEPA filter.
Drying during programme de-
activated
Drying cannot be selected at the start of a programme
because drying is not available for the selected
programme.
 Start the programme without drying.
Or:
 Have the drying parameters for this programme adjusted
by the Miele Customer Service Department.