Adding and dispensing chemical agents
56
Checking
consumption
Check consumption regularly by checking the fill levels in the supply
containers and replace containers in good time to avoid the
dispensing system being sucked completely dry.
Refill indicator
When the fill level is low in the DOS 3 supply container for neutralising
agent you are reminded to refill it.
Confirm the message shown with OK and
Refill the neutralising agent as described.
If it has run out, the machine will be locked for further use.
It will be ready for use again when the supply container has been
replaced.
Dispensing
neutralising agent
The dispensing concentration is set by the Miele Customer Service
Department.
Instrument care products
Instrument care products based on paraffin oils (white oils) can
damage elastomers and plastic in the machine.
Such care products must not be dispensed as chemical agents in
this machine even if they are recommended for machine use by the
care product manufacturer.
If required, paraffin oil based instrument care products can be used
after machine reprocessing within the scope of instrument care.
Observe the specifications of the manufacturers of the instruments
and care products.
It is acceptable however to reprocess instruments which have been
treated with such care products in this machine.
To Next Page
Loading...
