Areas of application
47
Baby bottles
The Baby bottles programme with thermal disinfection is intended for
reprocessing baby bottles and teats.
Baby bottles can be cleaned and disinfected in containers e.g. the
E 135 and teats in special inserts e.g. the E 364 for wide necked teats
and the E 458 for screw cap teats.
- Highly alkaline cleaning agents can etch and erase the graduated
markings on baby bottles. Please only use baby bottles with
dishwasher-proof level markings.
- If there is a delay of 4 hours or more before bottles can be
processed, fill them with water to prevent residues from drying on.
If the process is not to be followed by sterilisation, the load should
be dried completely before storage to avoid the development of
water-borne bacteria.
An adequate drying time must be selected to ensure this and the
drying result must be checked at the end of every programme.
Containers and inserts for baby bottles and teats are supplied with
their own operating instructions.
To Next Page
Loading...
