Problem solving guide
134
Problem Cause and remedy
Wrong code entered The PIN code entered is not the same as the code saved.
Enter the PIN code again.
Report the loss of the PIN code to the Miele Customer
Service Department.
Test programme: test object
can now be removed
This is not a fault.
A test programme is running to check performance. At
certain points in the programme the sequence is
interrupted so that samples can be taken.
Take a sample.
or
Wait. The programme will continue automatically in
approx. 30 seconds.
or
Continue the programme without delay by pressing the
Start/Stop button.
Programme cancelled This is not a fault.
A programme which was running was cancelled by the
user.
The wash cabinet interior can be very hot.
When the door is opened, hot steam and chemical
agents can escape. Protective measures for personal
safety must be observed.
Programme continued This is not a fault.
The process of cancelling a programme was not
completed.
The programme which was running continued without
interruption.
Peak load cut-out
This is not a fault.
Individual components of the machine are paused while
there is a peak load signal from your energy management
system.
All settings reset This is not a fault.
A user has restored factory default settings.
Confirm the message with OK.
All programme settings reset This is not a fault.
A user has restored the factory setting for the programme.
Confirm the message with OK.
To Next Page
Loading...
