Use
20
Stopping the roller
During ironing, press down the footswitch with your foot.
The roller stops moving. The heater plate remains engaged.
Remove your foot from the footswitch again to continue ironing.
The roller automatically begins to rotate again. The ironing process
continues.
Alternatively, the footswitch can be adjusted by Miele Service in
such a way that the heater plate exits Pause mode and the roller be-
gins to rotate when the footswitch is activated (domestic setting).
Stopping ironing
After ironing, let the roller run for about 10minutes at the minimum
heating temperature without feeding in any laundry to dry out the
roller cover completely.
Switch off the flatwork ironer by pressing the button.
The heater plate disengages and the fan runs for up to 10minutes to
cool down the ironer. The button flashes during this process.
Switch off the on-site main switch.
Ironing with a payment system
Press the button to switch on the ironer.
The symbol flashes.
Now insert the coin or token into the payment system.
The symbol will go out in the display.
Select the appropriate ironing temperature for the type of fabric.
Then select the desired roller speed.
When the indicator light goes out, the set target temperature
has been reached and the ironer is ready to start ironing. This is in-
dicated by a buzzer sounding.
The ironing time purchased starts when the buzzer sounds.
Press the button to start the ironing process.
If ironing commences before the target temperature is reached, the
timer starts counting down when the button is pressed.
The heater plate engages and the roller begins to rotate.
After the purchased ironing time has expired, the ironer emits an aud-
ible signal to indicate that the run-on time has started. The preset de-
fault run-on time is 1minute.
You can now finish ironing the item that has been fed in.
To Next Page
Loading...
