Notes
32
Fault messages
When a fault occurs, ironing is interrupted, the button flashes and a four-digit code ap-
pears in the display. Pressing the flashing button acknowledges the fault (the fault is
stored in the fault memory). The button flashes and the ironing process can be restar-
ted.
Fault message Fault
Heater fault
Electronic module fault
Drive fault
Fan fault
Electronic module fault
Appliance blocked
Drive voltage too low
General compressor fault
Low voltage
– Control system fault
If the fault message appears again, repeat the process or switch the ironer off before
switching it back on again. If the fault persists, call the Miele Customer Service Depart-
ment.
In the event of malfunctions, please alert the Miele Customer Service Department.
To Next Page
Loading...
