Installation and planning notes
22
Installation requirements
The flatwork ironer must only be set up by a Miele authorised and
trained service technician or an authorised dealer.
This flatwork ironer must be installed in accordance with all relev-
ant regulations and standards. Local energy supplier regulations must
also be observed.
This flatwork ironer must only be operated in a room that has suffi-
cient ventilation and which is frost-free.
Storage
The following conditions must be observed for transport and storage
of this flatwork ironer:
- Ambient temperature: -25°C to +55°C
- Humiditiy: 5% to 75%, non-condensing
- Maximum storage period: 2years
Operating conditions
In general, the operating conditions of DIN 60204 and EN 60204-1
apply.
- Ambient temperature: +5°C to +40°C
- Humidity: 10% to 85%
- At +21°C ambient temperature, the maximum permissible relative
humidity is 70%.
This ironer should not be operated in the same room as dry-
cleaning equipment using perchloroethylene or solvents containing
CFCs.
Collector motor sparking may convert solvent vapours into hydro-
chloric acid which can lead to consequential damage.
Ensure adequate ventilation is present in the room in which the
ironer is installed whilst it is being used.
To Next Page
Loading...
