Miele PW 6321 - Dispensing calibration

Optional modules
39
Dispensing calibration
Dispensing calibration is used to measure the throughput of the indi-
vidual dispenser pumps.
To go directly to
Dispensing cali-
bration when the
machine is
switched off:
 Press and hold multifunction button2 and switch the machine on
with “Power on”.
Dispensing calibration Main menu
Dispensing pump 1
Dispensing pump 2



Options:
- Dispenser pump 1to13
 Select a dispenser pump.
When a dispenser pump is selected, the following will appear in the
display:
100 ml

Dispensing calibration Dispensing pump 1
V:
P:
t:
s
No
0
0/1


Tip: The dispensing quantity can be set from 0to9,999ml in 1ml in-
crements.
 Press the multifunction button0/1.
The dispensing hose will fill up.
 Stop the process by pressing the 0/1button.
 Run the hose of the dispenser pump upwards into a measuring ves-
sel.
 Hold the entire measuring vessel above the dispenser pump while
doing this.
 Irritant detergents.
Skin and eye irritation.
Avoid contact with skin and eyes, wear protective clothing.
 Return to the main menu by pressing the “Back”button.
Dispensing calibration Main menu
Dispensing pump 1
Dispensing pump 2



 Select a dispenser pump.