Miele PW 6321 - Weighing System;Weighing Base; Resetting the Load Display to Zero

Optional modules
47
Weighing system/weighing base
If the machine is equipped with a weighing base, the load weight is
displayed in 0.5 lb (0.2kg) increments during loading. The maximum
load weight for the selected program is displayed beside it.
Resetting the load
display to zero
Do not place any items on the machine. Do not lean against the
machine.
This can influence the result of the measurement.
If the load display does not show “0.0” with an empty drum, set the
display to 0 using the button.
1 Cottons Hygiene 0,0/18,0
Rinse

140
+ 
 
Main wash
->I<-
1075 rpm
°F
lb
 If after resetting to 0 (taring), you discover an overlooked item in the
drum, the following will appear in the display:
1 Cottons Hygiene --,-/18,0
Rinse

140
+ 
 
Main wash
->I<-
1075 rpm
°F
lb
 Reset the display to0 using the button.
Tip: If the machine is overloaded, for example when laundry is wet, it
will operate in accordance with the nominal load after the program
starts. This value is also saved in the operating data module.
At the end of the program when the drum has stopped rotating, the
residual moisture in the laundry is shown in the display.
60 %




1
Whites
Programmende
Door can be opened.
Residual
moisture