Miele PW 6321 - Page 53

Frequently asked questions
53


Call Technical Service
if restart w/o success.

Door lock fault
 Press firmly against the door handle until the door lock audibly en-
gages and press the “START”button.



Heating system fault
Program stop. Press Start.
Program runs with cold water.
 Press the “START”button to continue the program without heating.
Tip: Disinfection programs will be canceled if this fault message ap-
pears.
 Contact CustomerService.



Drive motor fault
Program stop. Press Start.
Motor temperature too high.
 Allow the motor to cool down.


Imbalance fault
Call Technical Service
if restart w/o success.

Too large an imbalance. The imbalance switch has been triggered.
 Switch the machine off and back on again and press the
“START”button.



Drain valve fault
Call Technical Service
if restart w/o success.
 Check the on-site drainage system and press the “START”button.
A defective drain valve must only be repaired by CustomerService.



Dispensing system fault
Fill dispensing container ??. Press Start.
 Change the dispensing canister.