3. Select a programme and start it
28
Selecting Delay start (if required)
With delay start you can delay the
start of the programme: from
minutes up to (hours).
However: delay start cannot be used in
combination with the Warm air
programme.
For further information, see the "Delay
start" chapter.
Touch the sensor.
lights up brightly
Touch the or sensor repeatedly
until the required delayed start time
appears in the time display.
Start the programme
Touch the flashing Start/Stop sensor.
Start/Stop lights up
Note:
– The Perfect Dry indicator will only
flash/light up with programmes with
selectable drying levels (see also
"Operating the tumble dryer").
– This dryer measures residual
moisture content in the laundry to
determine the required programme
duration.
If the tumble dryer is loaded with dry
laundry or only a small load, it will be
dried/aired for a set duration. In this
case, Perfect Dry does not light up at
the programme end.
Avoid over-drying items of laundry
and garments.
Otherwise they can wear out!
Energy saving:
after 10 minutes, the indicators dim and
the Start/Stop sensor starts flashing.
Touch the Start/Stop sensor to switch
the indicators on again (this does not
have any effect on a running
programme).
To Next Page
Loading...
Need help?
General
