Installation and connection
59
Arranging the drain hose
Do not pull on the drain hose
and do not stretch it or allow it to
become kinked.
This could damage the hose.
There will be a small amount of residual
water left in the drain hose. Have a
container ready to collect this.
Pull the drain hose off its connection.
Unwind the hose and pull it carefully
out of the holders.
Allow any residual water to run into
the container.
Guide the hose to the right or left side
of the dryer, as required.
– If you are guiding it to the right you
can fit the hose into the groove.
– Leave the hose in the lower holder to
prevent it from being kinked by
mistake.
To Next Page
Loading...
