Programmable functions
68
Keypad tone
With this setting, you can activate/
deactivate a signal tone that will
sound each time a sensor is touched.
The volume of the keypad tone will
depend on the setting selected for "
Buzzer volume".
Options
= off
= on (default setting)
In the case of a selection that is not
allowed, a negative signal tone
sounds.
Lock code
The lock code prevents your dryer
being used without your knowledge.
When the code has been activated, you
have to enter a code after switching the
dryer on. Otherwise the dryer cannot be
operated.
Options
= Off (factory default)
= On
If option has been selected, after
switching on you will have to enter the
code before you can operate the dryer.
To use the dryer when the code is
activated
After the dryer is switched on, will
flash in the time display.
The code is and cannot be altered.
Touch the sensor until a flashes
in the first position.
Confirm with the Start/Stop sensor.
Enter the two other numbers in the
same way.
The dryer is ready for use after has
been entered and confirmed.
To Next Page
Loading...
Need help?
General
