Installation and connection
55
Rear view
a
Protruding lid for holding when
moving the dryer (see arrows)
b
Accessories for external drainage of
condensed water: hose clip, adapter
and hose holder
c
Hose for external drainage of
condensed water
d
Mains connection cable
Transporting the tumble dryer
to its installation site
Make sure the fixings at the back
of the lid are secure.
Otherwise there is a danger of the lid
being pulled off when carrying the
appliance.
Before carrying the appliance check
that the lid is secure where it
protrudes at the back of the
appliance.
Carry the tumble dryer by the front
feet and by the lid where it protrudes
at the back of the appliance.
Only transport the dryer as
illustrated. If transporting the dryer
on its side, it must be tipped towards
the left side.
If the tumble dryer has not been
transported as described, then it
must be left to stand for at least 1
hour before it is connected to the
electricity supply.
Otherwise the heat pump can be
damaged.
To Next Page
Loading...
Need help?
General
