Changing the programme sequence
35
You cannot change to another
programme once a programme has
started (this prevents unintentional
alterations).
If you try to change a programme,
lights up until the original programme is
reset.
Exception: if the programme selector is
turned to the position, the dryer will
switch off.
You will need to cancel the current
programme before you can select a
new one.
Bear in mind that hot steam can
escape after the door is opened.
Cancelling a programme while
it is running and selecting a
new programme
Touch the Start/Stop sensor.
The items will be cooled down, as long
as a certain drying time and drying
temperature has been reached.
If you press Start/Stop again during this
time, will light up.
To cancel, turn the programme
selector to .
Select and start a new programme
straight away.
Adding or removing laundry
after a programme has started
Touch the Start/Stop sensor.
The items will be cooled down, as long
as a certain drying time and drying
temperature has been reached.
If you press the Start/Stop sensor again
during this time, will light up.
Danger of burning.
Do not touch the back of the drum
when adding or removing items. The
drum and the items can be very hot.
Add or remove items.
Close the door.
To continue with the programme:
(select a drying level first of all, if
necessary)
Touch the Start/Stop sensor.
Programme duration
Altering the programme sequence can
cause the programme duration shown
in the time display to be adjusted.
To Next Page
Loading...
Need help?
General
