Miele TCE 620 WP - Programmable Functions Overview; Accessing and Selecting Functions

Programmable functions
65
Programming
You can use the programmable
functions to alter the dryer's
electronics to suit your requirements.
The programming is carried out in 8
steps (, ,  ... ) using the sensor
controls.
Accessing the programming level
Before you begin, ensure that:
– The dryer is switched on: a
programme is selected.
– The door of the dryer is open.
 Touch the Start/Stop sensor and
hold it down during steps -.
 Close the dryer door.
Wait until the Start/Stop sensor lights
up constantly ...
 ... and then release the Start/Stop
sensor.
Choosing and selecting the
programmable function
The number of the programmable
function will appear in the display as 
and a number:
e.g. .
 Touch the  or  sensor to scroll to
the next or previous programmable
function:
Programmable function
 Cotton drying levels
 Minimum iron drying levels
 Extended cool down
 Buzzer volume
 Keypad tone
 Lock code
 Conductivity
 Control panel switch-off status
 Dryer switch-off status
 Memory
 Anti-crease
 Buzzer is active
 Airways indicator
 Backlight brightness dimmed
 Confirm the selected programmable
function by pressing the Start/Stop
sensor.