What to do if...
52
Problem Cause and remedy
A programme does not
start
No obvious cause.
Connect the tumble dryer to the mains
Turn on the tumble dryer
Close the door
Check whether the mains fuse has tripped
Has there been a power cut? When power is restored
any previously running programme will restart
automatically.
Only the Start/Stop
sensor is now flashing
10 minutes after the end of the programme, the Start/
Stop sensor will begin to flash and the display will go
out: energy saving. This is not an error but a normal
function.
The drum will turn at intervals in the anti-crease
phase.
Touch a sensor to switch on the indicators.
See the "Programmable functions", chapter, "
Control panel switch-off status" section.
The dryer switches off
at the end of the
programme
The dryer switches off automatically: energy saving.
This is not an error but a normal function.
To switch the dryer on, select a programme.
Tip: you can change this. See the "Programmable
functions", chapter, " Dryer switch-off status"
section.
The interior drum
lighting does not come
on
The drum lighting will switch off automatically ...
... when the door is closed.
... after a few minutes when the door is open (to save
energy).
If the dryer is switched on, the drum lighting will
come on when the door is opened.
To Next Page
Loading...
